Henny Penny SCD-6/8 - Manual (Page 4)

Model SCD-6/8
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
On stacked units, the top unit must be removed from the top of
the SCD to replace the light fixture. Remove the stacking
brackets shown in Figure 2-1, then lift the top unit off
of the SCD.
2. Remove the top cover of the SCD.
3. Remove the wires from the faulty light fixture (Figure 2-8).
Figure 2-8
4. Push in on the mounting tabs of the light socket, and remove the
light socket from the interior of the unit (Figure 2-9).
5. Snap new light fixture into place from the interior of the unit.
6. Replace top cap (and re-stack units where applicable), and
restore electrical power.
Figure 2-9
2-7. POWER SWITCH 1. Remove electrical power supplied to the unit.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove the side panel closest to the controls.
2-6. LIGHT FIXTURE 1. Remove electrical power supplied to the unit.
REPLACEMENT
2-4 203