Henny Penny SCD-6/8 - Manual (Page 5)

Model SCD-6/8
2-7. POWER SWITCH (Continued) 3. Label and remove wires from the switch (Figure 2-10).
4. Check for correct continuity of switch.
Figure 2-10
5. If switch proves bad, push in on the mounting tabs and pull
switch from the front of the unit (Figure 2-11).
6. Install new switch in reverse order, and restore electrical power.
Figure 2-11
2-8. HEATERS 1. Remove electrical power supplied to the unit.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove the side panel closest to the controls.
203 2-5