HP 2910AL User Manual
Page 182
-------- --------- ---------- ---------- -------
-------- ---------- ----------
---------------
Configuring IP Addressing
Loopback Interfaces
ProCurve> show ip
Internet (IP) Service
IP Routing : Enabled
Default TTL : 64
ARP Age : 20
VLAN
IP Config IP Address Subnet Mask Proxy ARP
DEFAULT_VLAN Manual 10.0.8.121 255.255.0.0
No
VLAN2
Manual 192.168.12.1 255.255.255.0 No
VLAN3
Disabled
Loopback Addresses
Loopback
IP Config
IP Address Subnet Mask
lo1
Manual
172.16.110.2 255.255.255.255
lo2
Manual
172.16.112.2 255.255.255.255
lo2
Manual
172.16.114.1 255.255.255.255
Figure 8-7. Example of show ip Command Output
N o t e
The default loopback interface (
lo0) with IP address 127.0.0.1 is not displayed
in the
show ip command output because it is permanently configured on the
switch. To display the default loopback address, enter the
show ip route
command as shown in Figure 8-8.
8-18