Cli: viewing and configuring timep, Cli: viewing and configuring timep -18 – HP 2910AL User Manual
Page 206
Time Protocols
TimeP: Viewing, Selecting, and Configuring
ii. Enter the IP address of the TimeP server you want the switch to
use for time synchronization.
Note:
This step replaces any previously configured TimeP server
IP address.
iii. Press
[>]
to move the cursor to the
Poll Interval field, then go to
step 6.
5. In the
Poll Interval field, enter the time in minutes that you want for a
TimeP Poll Interval.
Press
[Enter]
to return to the Actions line, then
[S] (for Save) to enter the new
time protocol configuration in both the startup-config and running-config
files.
CLI: Viewing and Configuring TimeP
CLI Commands Described in this Section
Command
Page
show timep
[no] timesync
ip timep
dhcp
manual
server <ip-addr>
interval
no ip timep
This section describes how to use the CLI to view, enable, and configure TimeP
parameters.
9-18