HP 2910AL - Manual (Page 353)

Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
Syntax: [no] snmpv3 targetaddress < ipv4-addr | ipv6-addr> < name >
—Continued—
[timeout < value >]
(Optional) Time (in millisecond increments) allowed
to receive a response from the target before notification
packets are retransmitted. Range: 0-2147483647.
Default:
1500 (15 seconds).
[max-msg-size<size>]
(Optional) Maximum number of bytes supported in a
notification message to the specified target. Default:
1472
6. Create a configuration record for the target address with the snmpv3
params command.
Syntax [no] snmpv3 params <params_name> user <user_name>
Applies the configuration parameters and IP address
of an SNMPv3 management station (from the
params
<params_name> value configured with the snmpv3
targetaddress command in Step 5) to a specified
SNMPv3 user (from the
user <user_name> value
configured with the snmpv3 user command in Step 2).
If you enter the snmpv3 params user command, you must
also configure a security model ( sec-model) and
message processing algorithm ( msg-processing).
< sec-model < ver1 | ver2c | ver3 >
Configures the security model used for SNMPv3
notification messages sent to the management station
configured with the
snmpv3 targetaddress command in
Step 5.
If you configure the security model as ver3, you must
also configure the message processing value as ver3.
< msg-processing < ver1 | ver2c | ver3 > [noaut | auth | priv]
Configures the algorithm used to process messages sent
to the SNMPv3 target address.
If you configure the message processing value as ver3
and the security model as ver3, you must also configure
a security services level ( noauth, auth, or priv).
14-25