Honeywell HD4UX - Manual (Page 14)

14
Figure 6 Gimbal Adjustment
Adjusting the Lens Focus
Lenses are pre-focused at the factory but may require a final adjustment after installation
because the optical effect of the dome may cause a slight defocusing of the lens.
TECH TIP! To check the focus, hold the dome over the lens while making any adjustments.
To adjust the camera direction, view angle and focus, connect the service monitor cable
(supplied) to the video monitor output.
A
B
C
Locking screw. Loosen to
adjust Horizontal (B).
Set focus
(top) Set focal length
(bottom)
Locking
screw
Top view Angle view
Setscrews (x2). Loosen to
adjust Pan (C). Other setscrew
located on opposite side.
Joystick (5 way) See
Camera Functions .
Legend
A = Tilt rotation
B = Horizontal rotation
C = Pan rotation