HONDA 08V67-TE0-100A - Manual (Page 11)

© 2007 American Honda Motor Co., Inc. – All Rights Reserved. AII 37561-38377 (0711)
11 of 15
32. Install one wire tie with holder to the back-up sensor
harness 16-pin connector, and attach the wire tie to
the vehicle harness.
33. Mark the inside of the rear bumper:
• Locate the three marks on the inside of the
bumper at the center and left side.
• Using a pushpin, pierce the rear bumper at the
top and center of the three marks.
• Locate the three marks on the inside rear
bumper on the right side.
• Using a pushpin, pierce the rear bumper at the
bottom and the center of the right mark.
742410BE
VEHICLE
HARNESS
WIRE TIE WITH
HOLDER
BACK-UP SENSOR
HARNESS
6-PIN CONNECTOR
NOTE: There are several markings on the inside of the
rear bumper. Before piercing the rear bumper, verify you
have the correct locations.
742603BE
REAR BUMPER
PUSHPIN
REAR BUMPER
3 MARKS
3 MARKS
PUSHPIN
MARK
MARK
REAR BUMPER
www.collegehillshonda.com