HONDA 08V67-TE0-100A - Manual (Page 13)

© 2007 American Honda Motor Co., Inc. – All Rights Reserved. AII 37561-38377 (0711)
13 of 15
36. Install two center sensors into the 26 mm holes in the
rear bumper using the sensor clips. Note the
direction and location for each sensor.
37. Plug the four back-up sensor subharness 2-pin
connectors into each back-up sensor connector.
NOTE: The back-up sensor harness 6-pin connector
and the junction connector must be positioned on the
left side of bumper.
38. Attach the two center backup sensor subharness
clips to the holes in each center sensor clip.
742413BE
REAR
BUMPER
2 CENTER SENSORS
(Blue)
SENSOR CLIP
2 HOLES,
26 mm
Outside Inside
2 CENTER
SENSORS
(Blue)
REAR
BUMPER
742601BE
BACK-UP SENSOR
SUBHARNESS
4 BACK-UP SENSOR
SUBHARNESS 2-PIN
CONNECTORS
CORNER
SENSOR
RIGHT CENTER
SENSOR
LEFT CENTER
SENSOR
CORNER
SENSOR
JUNCTION
CONNECTOR
BACK-UP SENSOR
HARNESS 6-PIN
CONNECTOR
39. Secure the subharness to the bumper using four
harness tapes in the locations shown.
40. Attach one wire tie with holder clip to the back-up
sensor subharness junction connector and secure
the wire tie to the vehicle harness.
742602CE
BACK-UP SENSOR
SUBHARNESS
SENSOR
CLIP
SENSOR
CLIP
2 BACK-UP SENSOR
SUBHARNESS CLIPS
HOLDER
CLIP
BACK-UP
SENSOR
HARNESS
BACK-UP SENSOR
SUBHARNESS
JUNCTION CONNECTOR
WIRE TIE
WITH CLIP
www.collegehillshonda.com