HP 3500 - Manual (Page 53)

5. Press to select SYSTEM SETUP.
6. Press to highlight TRAY BEHAVIOR.
7. Press to select TRAY BEHAVIOR.
8. Press to highlight MANUALLY FEED PROMPT.
9. Press to select MANUALLY FEED PROMPT.
10. Press or to select ALWAYS or UNLESS LOADED.
11. Press to set the behavior.
12. Press M
ENU
.
PowerSave time
The adjustable PowerSave time feature reduces power consumption when the printer has
been inactive for an extended period. You can set the length of time before the printer goes
into PowerSave mode to 1 HOUR, 2 MINUTES, 30 MINUTES, 4 HOURS, 4 HOURS, 15
MINUTES, or 15 HOURS. The default setting is 30 MINUTES.
Note The printer display appears dimmed when the printer is in PowerSave mode. PowerSave
mode does not affect printer warm-up time, unless the printer is in PowerSave mode for
more than 8 hours.
To set PowerSave time
1. Press M
ENU
to enter the MENUS.
2. Press to highlight Configure Device.
3. Press to select Configure Device.
4. Press to highlight SYSTEM SETUP.
5. Press to select SYSTEM SETUP.
6. Press to highlight Powersave Time.
7. Press to select Powersave Time.
8. Press or to select the appropriate time period.
9. Press to set the time period.
10. Press M
ENU
.
To disable or enable PowerSave
1. Press M
ENU
to enter the MENUS.
2. Press to highlight Configure Device.
3. Press to select Configure Device.
4. Press to highlight RESETS.
5. Press to select RESETS.
6. Press to highlight POWERSAVE.
7. Press to select POWERSAVE.
ENWW Changing printer control panel configuration settings 41