HP 3500 User Manual
Page 68
20. Press
to save the syslog server.
21. Press
M
ENU
to return to the Ready state.
Setting the idle timeout
1. Press
M
ENU
to enter the MENUS.
2. Press
to highlight Configure Device.
3. Press
to select Configure Device.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EIO 1.
7. Press
to select EIO 1.
8. Press
to highlight TCP/IP.
9. Press
to select TCP/IP.
10. Press
to select CONFIG METHOD.
11. Press
to highlight MANUAL.
12. Press
to select MANUAL.
13. Press
to highlight MANUAL SETTINGS.
14. Press
to select MANUAL SETTINGS.
15. Press
to highlight IDLE TIMEOUT.
16. Press
to select IDLE TIMEOUT.
17. Press the
or
arrow to increase or to decrease the number of seconds for the idle
timeout.
18. Press
to save the idle timeout.
19. Press
M
ENU
to return to the Ready state.
Setting the link speed
By factory default, the link speed is set to AUTO. Use the following procedure to set a
specific speed:
1. Press
M
ENU
to enter the MENUS.
2. Press
to highlight Configure Device.
3. Press
to select Configure Device.
4. Press
to highlight I/O SUBMENU.
5. Press
to select I/O SUBMENU.
6. Press
to highlight EIO 1.
7. Press
to select EIO 1.
8. Press
to highlight LINK SPEED.
9. Press
to select LINK SPEED.
10. Press
to highlight the desired link speed.
56
Chapter 3 I/O configuration
ENWW