Heat & Glo Fireplace 8000TV-OAK - Manual (Page 36)

Heat & Glo • 8000TV-OAK, 8000TV-OAK-IPI, 8000TVLP-OAKIPI • 2058-900 Rev. N • 11/08 36
Figure 14.3 Fixed Glass Assembly
H. Fixed Glass Assembly
Removing Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
• Pull the four glass assembly latches out of the groove on
the glass frame. Remove glass door from the appliance
(see Figure 14.3).
Replacing Fixed Glass Assembly
• Replace the glass door on the appliance. Pull out and
latch the four glass assembly latches into the groove on
the glass frame.
I. Install the Mesh
The screen mesh is a protective barrier and must be at-
tached.
J. Install Trim and/or Surround
• Install optional trim kits and/or surrounds using the
instructions included with the accessory.
• Use non-combustible materials to cover the gap between
the sheet rock and the appliance (when applicable to the
model).
K. Install Hood
Hood is included with the front and is required in all instal-
lations.
GLASS
ASSEMBLY
LATCHES
(BOTH BOTTOM
AND TOP)
L. Shutter Settings
Shutter Settings
8000TV-OAK (NG) 1/4 inch
8000TV-OAK-IPI (NG) 1/4 inch
8000TVLP-OAKIPI Fixed