HP CM3530 - Manual (Page 49)

Menu item Sub-menu item Sub-menu item Values and Description
Address Manual Settings : Use this item to manually set IPv6
addresses on the print server.
Enable : Select this item and choose On to enable
manual configuration, or Off to disable manual
configuration.
Address : Use this item to type a 32 hexadecimal digit
IPv6 node address that uses the colon hexadecimal
syntax.
DHCPV6 Policy Router Specified : The stateful auto-configuration
method to be used by the print server is determined by
a router. The router specifies whether the print server
obtains its address, its configuration information, or
both from a DHCPv6 server.
Router Unavailable : If a router is not available, the print
server should attempt to obtain its stateful
configuration from a DHCPv6 server.
Always : Whether or not a router is available, the print
server always attempts to obtain its stateful
configuration from a DHCPv6 server.
Primary DNS Use this item to specify an IPv6 address for a primary
DNS server that the print server should use.
Secondary DNS Use this item to specify an IPv6 address for a
secondary DNS server that the print server should use.
Proxy Server Specifies the proxy server to be used by embedded
applications in the product. A proxy server is typically
used by network clients for Internet access. It caches
Web pages, and provides a degree of Internet security,
for those clients.
To specify a proxy server, enter its IPv4 address or
fully-qualified domain name. The name can be up to
255 octets.
For some networks, you may need to contact your
Independent Service Provider (ISP) for the proxy
server address.
Proxy Port Type the port number used by the proxy server for
client support. The port number identifies the port
reserved for proxy activity on your network, and can be
a value from 0 to 65535.
Idle Timeout This is the time period, in seconds, after which an idle
TCP print data connection is closed. The default is 270
seconds. To disable the timeout, specify 0.
IPX/SPX Enable Off : Disable the IPX/SPX protocol.
On (default): Enable the IPX/SPX protocol.
Frame Type Selects the frame-type setting for your network.
Auto : Automatically sets and limits the frame type to
the first one detected.
EN_8023 , EN_II , EN_8022 , and EN_SNAP : Frame-
type selections for Ethernet networks.
Table 2-11 Jetdirect menus (continued)
ENWW Initial Setup menu 35