HP CM3530 - Manual (Page 120)

Configure trays
The product automatically prompts you to configure a tray for type and size in the following situations:
● When you load paper into the tray
● When you specify a particular tray or media type for a print job through the printer driver or a
software program and the tray is not configured to match the print-job’s settings
The following message appears on the control panel: Tray <x> [type] [size] To change size or type,
touch “Modify”. To accept, touch “OK”.
NOTE: The prompt does not appear if you are printing from Tray 1 and Tray 1 is configured for Any
Custom and Any Type.
NOTE: If you have used other HP LaserJet product models, you might be accustomed to configuring
Tray 1 to First mode or Cassette mode. For this product, setting Tray 1 size to Any Custom is equivalent
to First mode. Setting size for Tray 1 to a setting other than Any Custom is equivalent to Cassette
mode.
Configure a tray when loading paper
1. Load paper in the tray. Close the tray if you are using Tray 2 or 3.
2. The tray configuration message appears.
3. Touch OK to accept the detected size and type, or touch Modify to choose a different paper size
or type.
4. Select the correct size and type and then touch OK .
Configure a tray to match print job settings
1. In the software program, specify the source tray, the paper size, and the paper type.
2. Send the job to the product.
If the tray needs to be configured, the tray configuration message appears.
3. Load the tray with the specified type and size of paper, and then close the tray.
4. Touch OK to accept the detected size and type, or touch Modify to choose a different paper size
or type.
5. Select the correct size and type and then touch OK .
Automatic overhead transparency sensing (auto sense mode)
The automatic media type sensor functions only when that tray is configured to the Any Type setting.
Configuring a tray to any other type, such as Bond or Glossy, deactivates the media sensor in that tray.
The product can automatically classify paper types into one of two categories:
● Non-transparency
● Transparency
For more control, a specific type must be selected in the job or configured in a tray.
106 Chapter 6 Paper and print media ENWW