HP CM3530 - Manual (Page 92)

USB connection
This product supports a USB 2.0 connection. You must use an A-to-B type USB cable that is no longer
than 2 m (6.56 ft).
Network configuration
You might need to configure certain network parameters on the product. You can configure these
parameters from the control panel, the embedded Web server, or for most networks, from the HP Web
Jetadmin software.
For a complete list of supported networks and for instructions on configuring network parameters from
software, see the HP Jetdirect Embedded Print Server Administrator’s Guide. The guide comes with
products in which an HP Jetdirect embedded print server is installed.
Supported network protocols
The product supports the TCP/IP network protocol, the most widely used and accepted networking
protocol. Many networking services utilize this protocol. The following tables list the supported
networking services and protocols.
Table 5-1 Printing
Service name Description
port9100 (Direct Mode) Printing service
Line printer daemon (LPD) Printing service
Advanced LPD (custom LPD queues) Protocol and programs associated with line-printer spooling
services installed on TCP/IP systems.
FTP TCP/IP utility for transferring data between systems.
WS Print Uses the Microsoft Web Services for Devices (WSD) Print
services on the HP Jetdirect print server.
WS Discovery Allows Microsoft WS discovery protocols on the HP Jetdirect
print server.
Table 5-2 Network device discovery
Service name Description
SLP (Service Location Protocol) Device-discovery protocol, used to help find and configure
network devices. Used primarily by Microsoft-based programs.
Bonjour Device-discovery protocol, used to help find and configure
network devices. Used primarily by Apple Macintosh-based
programs.
Table 5-3 Messaging and management
Service name Description
HTTP (Hyper Text Transfer Protocol) Allows Web browsers to communicate with embedded Web
server.
78 Chapter 5 Connectivity ENWW