HP CM3530 - Manual (Page 94)

Service name Description
benefits of encryption and authentication and allows for
multiple configurations.
Configure the network product
View or change network settings
You can use the embedded Web server to view or change IP configuration settings.
1. Print a configuration page, and locate the IP address.
● If you are using IPv4, the IP address contains only digits. It has this format:
xxx.xxx.xxx.xxx
● If you are using IPv6, the IP address is a hexadecimal combination of characters and digits.
It has a format similar to this:
xxxx::xxxx:xxxx:xxxx:xxxx
2. Type the IP address into the address line of a Web browser to open the embedded Web server.
3. Click the Networking tab to obtain network information. You can change settings as needed.
Set or change the network password
Use the embedded Web server to set a network password or change an existing password.
1. Open the embedded Web server and click the Networking tab.
2. In the left-side pane, click the Authorization option.
NOTE: If a password has previously been set, you are prompted to type the password. Type the
password, and then click the Apply button.
3. Type the new password in the Password box and in the Verify Password box.
4. At the bottom of the window, click the Apply button to save the password.
Table 5-5 Security features (continued)
80 Chapter 5 Connectivity ENWW