Hasselblad 848 User Manual
Page 11
11
Grasp the Batch Feeder firmly with one hand while holding the
batch-scan door open on the scanner with your other hand. Align the
connector and pins on the back of the Feeder with the holes and con-
nector inside the scanner. Gently press the Feeder down and in place,
making sure that the Feeder sits firmly and has a good connection
with the connector.
Turn on the scanner by pressing its on/off switch.
FlexColor detects that the scanner has been turned back on. The
Mount feeder
window updates with new instructions.
Click on
Done
to close the
Mount feeder
window.
If you have never used the Batch Feeder before, try to load it with a
full set of 10 original holders and scan them all. If the Feeder works
smoothly, then you are ready to begin work. However, if the scanner
has trouble moving the original holders in and out, then you may
need to align the Feeder to match your individual scanner. In this
case, please see “Aligning the Feeder” on page 23.
10.
11.
12.
13.