Hasselblad 848 - Manual (Page 25)


Figure 7: Bolts for adjusting the feeder angle
Use your fingers to turn the two adjustment bolts until that they look
as though they will hold the bottom of the Feeder at the correct angle.
Use the software-assisted procedure to remount the Feeder to the
scanner as described in “Mounting the Feeder” on page 8.
Check to see if the angle now looks correct. If not, then repeat this
procedure until the angle is correct (always use the software-assisted
procedure when mounting or unmounting the Feeder).
When the angle is set correctly, use the supplied adjustment tool to
tighten the two nuts on the back of the adjustment bolts.
Adjusting the Loading Position
The Feeder must be positioned so that it inserts its original holders di-
rectly into the clasp mounted on the drum inside the scanner. Use the
procedure below only if your original holders are not being drawn in and
out of the scanner smoothly during normal operation.
If the feeder is currently mounted, then use the software-assisted
procedure to unmount the Feeder as described in “Unmounting the
Feeder” on page 12.
7.
8.
9.
10.
1.