HP Home Theater System - Manual (Page 135)

Initial Configuration 129
Initial Configuration
Initial Startup
After you have connected the equipment, you are ready
to turn on the system.
1 Make sure the video and audio cables are
connected before you turn on the TV and the
HP Digital Entertainment Center.
2 Turn on all connected system equipment, such as TVs,
set-top boxes, and AV receivers.
3 Plug the HP Digital Entertainment Center AC power
cable into a wall outlet.
■ Use a surge protector to prevent power surges or
voltage spikes.
4 Press the On/Standby (power) button on the front
of the HP Digital Entertainment Center. The system
starts.
5 See “Syncing the Keyboard” on page 130.
The display on the TV screen may not be optimized until
after you set the display settings.
n
Set the volume to mid-level on the AV receiver
and on the TV.
DIGITAL VIDEO OUT
DVI
DIGITAL AUDIO OUT
COAXIAL
OPTICAL
10/ 100/ 1000
HI SPEED USB 2.0 ETHERNET 1394
AUDIO IN
R
L
AUDIO 7.1 PRE-OUT
SURROUND BACK SURROUND CENTER
SUB WOOFER
FRONT
R R R
L L L
VIDEO OUT
S-VIDEO COMPONENT
VIDEO
Y
Pb
VGA
Pr
INFRARED TRANSMITTER OUT 1 2
TV SOURCE 1 IN
VIDEO AUDIO S-VIDEO
R L
WIRELESS LAN 802.11 b/g
REMOVABLE ANTENNA ACTIVITY
LINK
CABLE/ANT. IN FM ANTENNA IN
AC IN 100-240V- 4/A 50/60Hz
TV SOURCE 2 IN
S-VIDEO AUDIO R L
75 Ω COAXIAL DUAL TUNER
Surge Protector
Line Conditioner
AC IN
110-240V 50-60Hz AC
Wall Outlet
HDTV / SDTV ANT. IN
ATSC TUNER
w
Make sure you have followed all safety
instructions for your HP Digital Entertainment
Center, especially the important AC power
information.
See “Safety Information” on page 17.
Power On
On/Standby