Satellite connection, One satellite receiver (ntsc) – HP Home Theater System User Manual
Page 99
Connecting TV Source In
93
Connecting TV Source In
Satellite Connection
(Location, availability, and number of connectors may vary.)
One Satellite Receiver (NTSC)
Connect the TV signal source from the satellite receiver
into the HP Digital Entertainment Center.
If you are using a satellite receiver (sold separately) with
S-video or composite video output, do the following:
1
Make sure that a coaxial cable connector from your
dish source is plugged into the satellite receiver In
connector.
2
Connect a video cable.
a
Choose a Video Out connector:
■
Coaxial (RF)
■
Video (composite)
■
S-video
b
Connect the video cable from the
satellite receiver back panel video output
connector.
c
Connect the video cable into the HP Digital
Entertainment Center back panel TV Source 1 In
connector.
3
Connect stereo audio cables (skip this step if using
coaxial [RF]):
a
From the satellite receiver back panel Audio Out
right (red) connector and Audio Out left (white)
connectors.
b
Into the HP Digital Entertainment Center back
panel TV Source 1 In Audio right (red) and Audio
left (white) connectors.
4
Connect the satellite receiver Infrared Transmitter
cable (required for signal). See “Infrared Transmitter
Connection” on page 97.