Humax CX-FOX C II - Manual (Page 46)

GB45
User’s Manual
8. Installation
8.1 Automatic Search
If the product is connected to the cable and TV, you can automatically search channels without entering
any other information.
1. Press the MENU button.
2. Select Installation using the  /  button and press the OK
or  button.
3. Select Automatic Search using the  /  button and press
the OK or  button.
Note: The default password is 0000. If you have forgotten your
password, please contact your local product distributor.
1. Search
Wait while the product searches for the channels, this may take a few minutes.
1. While operating search, the cursor is located at Stop.
Therefore, if you press the OK button during searching, the
operation stops and only the channels found so far will be
displayed.
2. If the search operation is successfully completed and the
channel does not exist, press the OK button and try to reset
the search operation again if necessary.
3. You can delete unnecessary channels from the searched
channels. Select the channels to delete and press the OK
button. Then select Delete and press the OK button. To
delete all channels, select Select All to select all channels,
select Delete and press the OK button.
4. When completing channel search and deleting unnecessary
channels, select Save and press the OK button to save the
changes.