Harley-Davidson B3160 - Manual (Page 30)

30
TM
IMPORTANT! Use only Power Wheels ® 12 volt battery.
Use of any other battery will damage your vehicle. Make
sure that you charge the battery for at least 18 hours using
the enclosed Power Wheels
® 12 volt charger before
operating your vehicle for the first time. Charge the
battery for at least 14 hours after each use of the vehicle.
Never charge the battery longer than 30 hours. Failure to
follow these instructions may damage your battery and will
void your warranty.
TM
• Remove the seat. Press the tab at the back of the seat
and lift.
• Place the Power Wheels ® 12 volt battery upright in the
battery compartment. Make sure the battery terminals
face the rear of the vehicle.
• Fit the battery clamp over the battery.
• Insert a screw through each end of the battery clamp
and into the screw pegs in the vehicle body.
• Tighten the screws using a Phillips screwdriver.
Do not over-tighten.
TM
• Plug the motor harness connector into the battery.
Push firmly to make sure the connector is secure in
the battery.
• Replace the seat on the vehicle.
Vehicle
Body
Power Wheels ®
12 Volt Battery
Battery
Compartment
Battery Installation
Battery Clamp
Screw
Peg Screw
Peg
Battery
Motor
Harness
Connector
H
1
2
3