Hitachi P50V702 - Manual (Page 38)

38
Channel Manager
Select CHANNEL MANAGER to set your Antenna options, run
Auto Channel Scan, Check Signal Meter and Set Channel List.
Press CURSOR PAD 1. , to highlight functions.
Press the SELECT button or CURSOR PAD 2. to select.
+
Video
Audio
TV Guide On Screen
Channel Manager
Locks
Timers
Setup
Move SEL Select
Power Swivel
OR
Channel List
Auto Channel Scan
Signal Meter
Channel Manager
Move SEL Select
Signal Meter
Select SIGNAL METER when using an indoor or outdoor antenna.
This feature will show the signal strength and peak values of the
Antenna signal to help you adjust your antenna to optimize signal
reception.
Move SEL Return
Signal Meter
Channel Manager
Channel 3-1
Strength 91
Peak
91
SNR 10
Close
Use the CURSOR PADS buttons , and the SELECT button to
highlight and select CLOSE to exit.
The Signal Meter will not be available (grayed out)
when watching analog channels.
Auto Channel Scan
This feature will automatically store active Analog and Digital
channels in Auto Channel Scan memory.
Channel Manager
Source Air
Auto Channel Scan
Auto Channel Scan
Move SEL Return
Start Reset
Use the CURSOR buttons 1. or to highlight AIR, CABLE (1)
or CABLE(2) source.
NOTE
Press the CURSOR buttons 2. or to highlight the START or
RESET option.
Press the SELECT button to select. 3.
If certain channels are poor or not possible in cable(1)
mode, set cable source to cable(2) by using the
CURSOR buttons or .
Channel List
This function allows you to review which channels are labeled (ID),
which have been added to CHANNEL MEMORY (SKIP), which
are protected by LOCK and which are your FAVORITE (FAV)
CHANNELS.
FAV CH# Skip Lock ID
On Off ------
4 On Off ------
5 On Off ------
6 On Off ------
7 On Off ------
8 On Off ------
9 On Off ------
10 On Off ------
3-1
Channel List
Channel Manager
No Info --:-- AM --:-- AM
Move Return INFO DETAIL
Use the CURSOR PAD to navigate the Channel List. 1.
Press the SELECT button to select ON or OFF on the SKIP 2.
and LOCK columns.
To select LOCK column, input the access code.(Default access 3.
code: 0000)
Press the FAV button to set or remove the FAVORITE 4.
settings.
Press the EXIT button to return to normal viewing. 5.
The Channel List cannot be updated by only
changing the cable source. Auto Channel Scan must
be performed for the Channel List to be updated.
NOTE
NOTE
IMPORTANT NOTICE
United States federal law requires broadcasters to stop transmitting
analog (non-digital) television signals after February 17, 2009.
Accordingly, this TV’s analog tuner will not be capable of receiving
over-the-air analog television broadcasts after such analog
broadcasts are no longer available.
After February 17, 2009, this TV’s analog tuner will continue to
work with compatible cable and satellite TV systems, gaming
consoles, VCRs, DVD players and other similar products.
Both before and after February 17, 2009, this TV’s digital tuner will
receive available over-the-air digital television broadcasts using an
antenna and other digital television broadcasts using compatible
cable, satellite or other digital television system connections.
Please review this Operating Guide for further information
regarding such connections.
Hitachi supports the DTV transition and as a member of the DTV
Transition Coalition urges consumers to visit these web sites for
interactive guides and further detailed information:
www.dtvtransition.org •
www.myceknowhow.com •
www.dtv2009.gov •
www.youtube.com •