Hotpoint EW93 - Manual (Page 33)

33
Care and Cleaning (cont.)
CLEANING THE DOORS
Take particular care not to damage the inner surface of the door inner glass that is
coated with a heat reflective layer. Do not use scouring pads, or abrasive powder,
which will scratch the glass. Ensure that the glass panel is not subjected to any sharp
mechanical blows.
Stubborn stains can be removed by using a fine steel wool soap pad. For slight soiling the
inner glass panel may be cleaned, while still warm, without removing it from the door. After
cleaning, rinse and dry with a soft cloth.
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop down doors, except take care to
support the weight of the inner glass when removing and refitting.
DROP DOWN DOORS
Remove the door inner glass as follows.
1.
Open the door fully.
2. Carefully slide the inner glass towards you and withdraw it from its locating
slots. Ensure that the door is not allowed to slam shut, due to the reduction in
door weight. Clean the glass as described above.
3. The inside of the outer door glass can now be cleaned while still fitted to the
cooker.
NEVER OPERATE THE COOKER WITHOUT THE INNER DOOR GLASS IN POSITION.
Refit the door inner glass as follows.
1.
Open the door fully.
2. Locate the inner door glass into its slots, so that the printing is readable from the
face nearest the oven in the closed position and the widest black band is towards
the bottom of the door. The inner door glass has a special reflective coating on
one side, in order to minimise surface temperatures and energy consumption
during use, it is important it is fitted correctly.
3. Carefully slide the glass into its slots as far as it will go.