Hill Phoenix KRZH - Manual (Page 11)

12
Install Upper Kickplate Retainer &
“J” Rail
Attach the upper kickplate retainer by
placing it against the bottom of the tank.
Line up the retainer with the kickplate
bracket and attach with the screws
provided. Set the “J” rail flush to the
floor and attach it to the kickplate
bracket with the screws provided.
11
Caulk Pipe Chase, Install Acrylic Tape
Seal joints along pipe chase seam with
the caulk provided. Apply acrylic tape
over pipe chase seam. Tape is found
with the ship loose items and acts as a
watershed preventing water from settling
in case joint.
16 15 14
13
10 9 8
Install Bumper Trim
Insert the bumper trim into the track that
is mounted to the front panel of the
case.
Install End Kickplate
End kickplates are installed only on
cases with ends. Fit the end kickplate
under the end and secure it to the base-
frame.
Insert Kickplate
Insert top of kickplate into the upper
kickplate retainer. Slide the kickplate up
into retainer then down on the “J” rail.
Install Pedestals
The pedestals line-up at the corner of
the case that is located at the end of a
line-up. Attach the pedestal to the kick-
plate bracket with the screws provided.
Add Sealant to Top Case Joint.
Once cases are pushed tightly together
and bolted run a bead of sealant
along the top joint.
Bolt Cases Together Using Bolt
Holes Provided
Push cases tightly together. Bolt
cases together through the four holes
provided. Tighten until all margins
are equal; do not over tighten. Remove Shipping Accessories
From Case. Add Sealant.
Remove anything from case that may
interfere with case joining (eg. ship-
ping braces). Run a bead of sealant
around entire end before pushing
cases tightly together.
7
ACRYLIC
TAPE
PIPE
CHASE
CAULK
1 2
3
5
CAULK
4
UPPER
KICKPLATE
RETAINER
KICKPLATE
BRACKET
TANK
KICKPLATE
BRACKET
BUMPER
TRIM
END
KICKPLATE
UPPER
KICKPLATE
RETAINER
PEDESTAL
“J” RAIL KICKPLATE
BASEFRAME
TRACK
“J” RAIL
PEDESTAL