Hitachi HV-D25 - Manual (Page 60)

47
Function Selection by Internal Switch Setting
SW405
For connection with the remote control box RC-C10,
set SW405 to the RC-C10 position.
For connection with the personal computer, set SW405
to the RS-232C position.
At shipment from factory, SW405 is set at the RC-C10
position.
Connectors
MULTI connector (SDEB-9S) REMOTE connector (HR10A-7R-4S)
Pin No. Signal designation Pin No. Signal designation
1 GND 1 +12V output
2 WE 2 RXD/SD input
3 R/R-Y/C output 3 TXD/SD output
4 G/Y output 4 GND
5 B/B-Y output
6 VBS output
7 SYNC output
8 HD output
9 VD output
Use M2.6 plug retaining screws.