Hatco FR2 Series - Manual (Page 13)

MAINTENANCE
11 Form No. FR2M-0604
6. After cleaning, drain all expended solution
from the unit through the sump drain.
7. Thoroughly wash heater tank with fresh water
for several minutes until discharge is clear
and all deliming solution has been removed
and rinsed.
8. Close sump drain by moving handle all
of the way forward until it stops.
9. Follow normal operation instructions.
CAUTION
Do not turn the electrical current to the unit
on until the holding vessel has been filled
with water or element burnout may occur.
WARNING
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact
the Hatco Service Department at 800-558-0607
or 414-671-6350; fax 800-690-2966 or
international fax 414-671-3976.
WARNING
This product has no “user” serviceable parts.
To avoid damage to the unit or injury
to personnel, use only Authorized Hatco
Service Agents and Genuine Hatco Parts
when service is required.
WARNING
Genuine Hatco Replacement Parts are specified
to operate safely in the environments
in which they are used. Some aftermarket
or generic replacement parts do not have
the characteristics that will allow them
to operate safely in Hatco equipment. It
is essential to use Hatco Replacement Parts
when repairing Hatco equipment. Failure
to use Hatco Replacement Parts may subject
operators of the equipment to hazardous
electrical voltage, resulting in electrical
shock or burn.