Heath Zenith Motion Sensing Diecast Metal Lantern 9600LED series - Manual (Page 4)

4 598-1338-03
FinaL assemBLy
1. Push the wires into the junction box. Make sure
none of the wires get pinched.
2. Slide the fixture assembly onto the mounting screws.
Tighten decorative nuts removed in step 1 of Instal-
lation section securely against fixture base.
Junction Box
Mounting Screw
Decorative Nut
3. Caulk around fixture base with silicone weather
sealant.
4. Install the three LED Lamps (Lights of America
Model No. 2025LEDE12 included). Note: This
fixture’s E12 candelabra base uses either LED
Lamps (1.5W maximum each) or tungsten in-
candescent Type “B” bulbs (60 Watt maximum
each).
5. Insert threaded rod of finial through top cover. Slide
star washer onto rod and thread the nut onto the
rod. Tighten securely.
6. Place top cover onto fixture and attach using
the two decorative nuts (included). Hand tighten
only.
Top Cover
Decorative Nut
3 Light Bulbs
(60 Watt
Maximum each)
Fixture
Assembly
Finial
Star Washer
Nut