HP 2610-PWR User Manual
Page 323
ProCurve Stack Management
Configuring Stack Management
Figure 8-8. The Default Stack Configuration Screen
3. Move the cursor to the Stack State field by pressing
[E]
(for
Edit).
4. Do one of the following:
• To disable stacking on the Candidate, use the Space bar to select
the
Disabled option, then go to step 5.
Note:
Using the menu interface to disable stacking on a Candidate
removes the Candidate from all stacking menus.
• To insert the Candidate into a specific Commander’s stack:
i. Use the space bar to select Member.
ii. Press
[Tab]
once to display the
Commander MAC Address param
eter, then enter the MAC address of the desired Commander.
• To change
Auto Join or Transmission Interval, use
[Tab]
to select the
desired parameter, and:
– To change Auto Join, use the Space bar.
– To change Transmission Interval, type in the new value in the
range of 1 to 300 seconds.
Note:
All switches in the stack must be set to the same transmis
sion interval to help ensure proper stacking operation. ProCurve
recommends that you leave this parameter set to the default 60
seconds.
Then go to step 5.
8-17