HP 2610-PWR - Manual (Page 35)

Static Virtual LANs (VLANs)
Port-Based Virtual LANs (Static VLANs)
Per-Port Static VLAN Configuration Options
The following figure and table show the options you have for assigning
individual ports to a static VLAN. Note that GVRP, if configured, affects these
options and VLAN behavior on the switch. The display below shows the per-
port VLAN configuration options. Table 2-2 briefly describes these options.
Enabling GVRP causes “No” to display as “Auto”.
Example of Per-Port
VLAN Configuration Example of Per-Port
with GVRP Disabled VLAN Configuration
(the default) with GVRP Enabled
Figure 2-5. Comparing Per-Port VLAN Options With and Without GVRP
Table 2-2. Per-Port VLAN Configuration Options
Parameter Effect on Port Participation in Designated VLAN
Tagged Allows the port to join multiple VLANs.
Untagged Allows VLAN connection to a device that is configured for an untagged
VLAN instead of a tagged VLAN. The switch allows no more than one
untagged VLAN assignment per port.
No
- or ­
Auto
No : Appears when the switch is not GVRP-enabled; prevents the port from
joining that VLAN.
Auto : Appears when GVRP is enabled on the switch; allows the port to
dynamically join any advertised VLAN that has the same VID
Forbid Prevents the port from joining the VLAN, regardless of whether GVRP is
enabled on the switch.
2-9