HotBrick VPN 800/8 F - Manual (Page 9)

HotBrick, Tel: 305-398-0888, Fax: 305-398-5966
Rear Panel
Figure 1-3: Rear Panel
AC 100V ~ 240V Connect to AC100~240V / 50~60Hz with AC power cord.
Default Settings
When the VPN800/8 F Firewall has finished booting, all configuration settings will initially be set to the
factory defaults, including:
 IP Address set to its default value of 192.168.1.1, with a Network Mask of
255.255.255.0
 DHCP Server is enabled
 User Name: admin
 Password cleared (no password)
TFTP Download
This setting should be used only if your VPN800/8 F Firewall interface can’t be accessed, and you wish to
restore it by uploading new firmware. In that case use the following procedure:
1. Power on the VPN800/8 F Firewall.
2. Use the supplied Windows utility or a TFTP client program to apply the new firmware. If you are
using the supplied Windows TFTP program, the screen will look like the following example.
Figure 1-4: Windows TFTP utility
 Enter the name of the firmware upgrade file on your PC, or click the "Browse" button to
locate the file.
 Enter the LAN IP address of the VPN800/8 F Firewall in the "Server IP" field.
 Click "Upgrade Firmware" to send the file to the Multi-WAN VPN Link Balancer.
3. When uploading is finished the unit should function normally, using the default settings.
9