Huffy 1C4880-A01 - Manual (Page 8)

3. Assemble the quick release mechanism to the front wheel:
- Remove the adjusting nut [4] and one spring from the quick release mechanism
- Put the quick release mechanism through the front wheel hub
- Put the spring and adjusting nut back on the quick release mechanism
- Do not tighten the adjusting nut at this time.
4. Assemble the front wheel to the fork:
NOTE: The words “open” and “close” are on opposite sides of the quick release lever.
- Move the quick release lever [1] to the “open” position [2] so the word “open” is pointing away
from the wheel
- Put the wheel between the fork legs [3]. Make sure the axle is against the bottom of the
slot in each fork leg.