Hitachi VT-FX6404A - Manual (Page 62)

62
Note: If program is overlap, the VCR gives you an error message that disappears from the screen in about 5
seconds.
8 Press the POWER button to turn off the VCR.
The delayed recording indicator will display on the VCR.
This tells you that the VCR will automatically record at the times and dates you have programmed.
Note: If a cassette has not been inserted or a cassette without safety tab has been inserted, the delayed
recording indicator will flash to warn you. The cassette without safety tab will be ejected automatically. Be sure to
insert a cassette with safety tab intact.
The VCR will automatically give a warning display on the screen 5 minutes before timer recording is to start.
When you have set up all the timed recordings you want:
• Don't forget to load a videocassette (With the safety tab still attached) to record on.
• If you have installed a cable box (see page 23), turn on the cable box and select the channel
you want to record on the cable box before recording starts.
Important: Your timed recording settings take effect when you turn off the power on the VCR.
Caution of VCR Plus+ Recording
After entering a PlusCode number, check the information displayed with the "PROGRAM REVIEW". If there is
(are) any unnecessary program (s), please cancel or correct it (them). Please refer to page 49, "Reviewing what
you have programmed".
PROGRAM REVIEW
•
Reviewing what you have programmed
You can look back over any of the recordings you have preset and if you need to, clear out any of the programs.
Normal programs will clear automatically once recording is complete, but daily and weekly setting must be cleared
out manually.