HSM FA 400.2 - Manual (Page 7)

0702 7
FA 400.2
Ready for operation
Green LED
Waste bag full
Red LED
Start button
The shredder switches on.
The feed belt moves in the intake
direction.
Stop button
The cutting block and feed belt stop.
The shredder is in standby mode.
Reverse button
The cutting block and feed belt run in
reverse.
Paper jam or overload
Red LED
Door open
Red LED
7. Start-up, inspecting the safety
devices
Attaching the waste bag (Solo version)
• Open the front door and pull out the waste trolley.
• You can modify the trolley from a double-chamber to a
single-chamber system by removing the brackets (1).
1
• Put in a new waste bag and fold it approximately 20
cm over the top frame tube. When using a two-cham-
ber system, make sure that there is also around 20
cm of plastic foil below the brackets (1).
• Push in the waste trolley and close the front door.
Switching on the shredder
• Pull out the emergency stop button.
• Solo-version: Turn the main switch to the I
position.
Combination-version: Turn the main switch
on the baling press to the I position.
The green "Ready for operation" LED
lights up.
Note:
There is a safety switch on the front door
of the shredder. The machine can only be
switched on when the door is shut.
• Press the green start button.
The cutting block and feed belt start up.
Caution!
The feed belt can run in reverse if the phase
wires in the power plug are incorrectly con-
nected.
Turn off the main switch immediately and
pull out the power plug!
Have an electrician change two of the three
phase wires
6. Operating and display elements on the keypad