HSM FA 400.2 - Manual (Page 8)

8 0702
FA 400.2
Place the material to be shredded on the loading tray and
then place batches on the feed belt.
If material that is not supposed to be shred-
ded is mistakenly placed onto the belt, never
attempt to pull it out.
• Press the stop button.
The drive stops.
• Press the reverse button.
The cutting block and feed belt run in
reverse.
• You can now remove the material from the
belt and start the shredder again by press-
ing the start button.
Waste bag full
The red LED on the keypad lights up. The
shredder switches off automatically.
• Press the reverse button for approx. 3
seconds.
Part of the material is pulled back into
the apparatus.
• Open the front door and shake the waste
trolley.
The cut material spreads in the cut mate-
rial sack and does not fall into the interior
of the shredder.
• Pull the waste trolley out and change the
cut material sack.
• Push the trolley back in and start the
shredder again by pressing the green start
button.
Inspecting the safety devices
Check that the safety devices are working
properly:
• At the start of each shift
• After any maintenance or repair work
Do not start the machine until you have
checked the emergency stop button and the
door switch and found them to be in perfect
working order. If any defect arises during
operation stop the machine immediately and
make sure it is corrected.
Checking the emergency stop button
Press the emergency stop button
while the machine is running.
The shredder must switch off immedi-
ately. The cutting block and the feed
belt must stop.
The machine will only start again once
you have pulled out the emergency
stop button again.
Inspecting the door switch
• Open the front door.
The red "door open" LED must light up.
The cutting block and feed belt must
stop.
After you close the door, the LED should go
out and you can start the machine again by
pressing the start button.
Shredding material