HSM FA 400.2 - Manual (Page 9)

0702 9
FA 400.2
8. Malfunctions
Check the following before calling customer service:
• Is the power plug connected?
• Is the shredder switched on?
• Is the front door closed?
• Is the waste bag full?
• Is there a paper jam in the shredder?
• Has the motor been overloaded?
Paper jam (excessive paper feed)
The red LED on the keypad blinks
The cutting block automatically runs in
reverse for several seconds.
Caution!
The blade rollers can still cause injuries
even while they are not running. Do not
reach into the cutting apparatus! Wear
safety gloves!
Do not alternately press the "Forwards" and
"Reverse" buttons to remove the blockage.
This will damage the shredder.
• Take out the pile of paper.
• Press the green start button and put less
paper on the feed belt.
Electric motor overheated
The red LED on the keypad lights up.
The shredder switches off automatically.
• Let the motor cool down for 20 - 30 min-
utes.
• Press the green start button.
Door open
The red LED on the keypad lights up.
The shredder switches off automatically.
• Close the front door.
• Press the green start button.
Stopping the shredder
• Press the stop button.
The cutting block and feed belt stop.
The shredder switches to standby mode.
Switching off the shredder
• Turn the main switch on the paper shred-
der or the baling press to 0.
You can secure the main switch in this
position using a padlock.