Honeywell TN924W - Manual (Page 20)

39
Indicator
displayed
Temperature
Range
Humidity
Range
Shows current condition
COMFORT
20°C to 25°C
(68°F to 77°F)
40%RH-
70%RH
Ideal for both relative
humidity and temperature
WET
-5°C to 50°C
(23°F to122°F)
OVER
70%RH
Contains excess moisture
DRY
5°C to 50°C
(23°F to122°F)
BELOW
40%RH
Contains inadequate
moisture
ACCESSING TEMPERATURE AND HUMIDITY WINDOW
Press UP or DOWN until the IN icon
on the upper right will flash.
VIEWING REMOTE (CHANNEL) TEMPERATURE AND HUMIDITY
Static Display:
In Temperature and Humidity Window, press the CHANNEL button to recall a different
channel.
Channel Auto-Scan Display:
To enable automatic scan of the different channels, press and hold CHANNEL, until the
3
icon is displayed. Each valid channel will be alternately displayed with a 5 seconds
delay.
NOTE: The channel Auto-scan feature can be active only if there are more than one
remote sensors operating and are set to different channels.
RECALLING TEMPERATURE AND DEW POINT INFORMATION
In Temperature and Humidity Window press SET button recalling either:
• Temperature and relative humidity
• Dew point and relative humidity
PROGRAMMING TEMPERATURE IN CELSIUS OR FAHRENGEIT
In Temperature and Humidity Window, press and hold SET to toggle the temperature
in Celsius (ºC) or Fahrenheit (ºF).
ACTIVATING OR DEACTIVATING ALARMS
In Temperature and Humidity Window, press the ALARM/CHART to recall a current
40
temperature for the corresponding channel, the upper temperature alert with ▲icon (if
disabled, displays OFF), or lower temperature alert with ▼ icon (if disabled, displays
OFF).
Once the above alerts are displayed, press the UP or DOWN to enable or disable the
corresponding alert.
PROGRAMMING ALARMS
• In the Temperature and Humidity Window, press ALARM/CHART selecting
the desired alarm.
• Press and hold ALARM/CHART button until the remote temperature and ▲or
▼ icon starts flashing.
• Adjust the temperature digits for the Temperature Alarm using the UP or
DOWN. Press and hold either button for fast digits advance
• Press the ALARM/CHART to confirm selection and return to the temperature
alarm selection screen
VIEWING REMOTE TEMPERATUR AND HUMIDITY MAX/MIN READINNGS
In the Temperature and Humidity Window press the MEM button recalling:
• Current temperature and humidity
• Minimum temperature and humidity
• Maximum temperature and humidity at the remote location.
RESETTING REMOTE TEMPERATURE AND HUMIDITY MEMORY
In the Temperature and Humidity Window, press and hold MEM button to clear
memory for all channels.
REMOTE SENSOR STATUS
The wave icon above the current channel number shows the connection status of the
corresponding remote sensor:
Icon Status
Searching for the signals from the remote sensor
Corresponding remote sensor signal received successfully
No signals received for over 15 minutes
ALL REMOTE SENSORS SIGNAL ACTIVATION
The main unit can be manually activated to search for the signals from remote sensors
by pressing and holding DOWN button.