Document Outline

• Cover
• Important information
  • Safety warnings, cautions and important information
  • Environmental requirements
• Chapter 1: About your interactive whiteboard system
  • SMART Board 480iv interactive whiteboard system features
    • SMART Board 480 interactive whiteboard
    • SMART V25 projector
  • Included accessories
    • Pen
    • Remote control
  • Optional accessories
• Chapter 2: Installing your interactive whiteboard system
  • Choosing a location
  • Choosing a height
  • Securing the interactive whiteboard system
  • Installing your audio system
  • Routing the cables
  • Installing SMART software
• Chapter 3: Using your interactive whiteboard system
  • Using your projector
    • Using your remote control
      • Installing the remote control battery
      • Using the remote control buttons
      • Adjusting projector settings
    • Focusing the image
    • Adjusting the image
    • SMART V25 projector connection diagram
  • Using your interactive whiteboard
• Chapter 4: Integrating other devices
  • Video format compatibility
    • Native video format
    • Video format compatibility
    • HD and SD signal format compatibility
    • Video system signal compatibility
  • Connecting peripheral sources and outputs
• Chapter 5: Maintaining your interactive whiteboard system
  • Maintaining your interactive whiteboard
  • Focusing and adjusting the projector image
  • Replacing the projector lamp
    • Removing and replacing the projector lamp module
    • Resetting the lamp timer
• Chapter 6: Troubleshooting your interactive whiteboard system
  • Correcting image alignment issues
  • Diagnosing issues using the interactive whiteboard system indicators and cont...
    • Interactive whiteboard indicators and controls
    • Projector lights and status
    • Projector error states
      • Your projector doesn’t respond to commands
      • The “Projector Overheated” message appears
      • The “Fan Failure” message appears
      • The “Color Wheel Failure” message appears
      • The “Lamp Failure” message appears
      • The projector Power light isn’t lit
  • Resolving network communication issues
  • Resolving audio issues
  • Resolving video issues
  • Resolving image issues
    • Loss of signal
    • No projected image
    • Partial, scrolling or incorrectly displayed image
    • The image from your connected laptop computer isn’t projected
    • Unstable or flickering image
    • Your image has a vertical flickering bar
    • Unaligned projected image
  • Accessing the service menu
    • Retrieving your password
    • Resetting the projector
  • Locating serial numbers
  • Transporting your interactive whiteboard system
• Appendix A: Remotely managing your interactive whiteboard system
  • Web page management
    • Accessing web page management
    • Home
    • Control panel
    • Network settings
    • E-mail alerts
    • Password settings
  • Connecting your room control system to the SMART V25 projector
    • Pin configuration on the projector’s RS-232 connector
    • Serial interface settings
  • Projector programming commands
    • Projector power state controls
    • Command inventory
    • Value-based command methods
      • Absolute values and adjustment values
      • Video source specification values
    • Power state controls
    • Source selection controls
    • General source controls
    • Additional VGA source controls
    • Additional composite video source controls
    • Audio output controls
    • Network controls
    • System controls
  • Simple Network Management Protocol (SNMP)
• Appendix B: Hardware environmental compliance
  • Waste Electrical and Electronic Equipment regulations (WEEE directive)
  • Restriction of Certain Hazardous Substances (RoHS directive)
  • Batteries
  • Packaging
  • China’s Electronic Information Products regulations
  • U.S. Consumer Product Safety Improvement Act
• Index