Smart Technologies SMARTBoard 480iv - Manual (Page 66)

Network settings
This menu allows you to enable or disable Dynamic Host Control Protocol (DHCP) and to set the
network-related addresses and names.
Submenu setting Description
DHCP Turns the network’s DHCP on or off.
l
On automatically assigns the DHCP server’s IP address to the
projector.
l
Off enables you to assign an IP address manually.
IP Address Displays the projector’s IP address in values between 0.0.0.0 and
255.255.255.255.
Subnet Mask Displays the projector’s subnet mask number in values between
0.0.0.0 and 255.255.255.255.
Gateway Displays the projector’s default network gateway in values between
0.0.0.0 and 255.255.255.255.
DNS Displays the projector’s IP address for your network’s primary domain
name server in values between 0.0.0.0 and 255.255.255.255.
Group Name Displays the projector’s workgroup name (maximum 12 characters).
Projector Name Displays the projector’s name (maximum 12 characters).
Location Displays the projector’s location (maximum 16 characters).
Contact Displays the contact name or number for projector support (maximum
16 characters).
SNMP Turns the SNMP’s MIB function on or off.
Read-Only Community Sets a password with each SNMP get request that enables access to
the device.
N
N O T E
The default for Read-Only Community is public.
Read/Write Community Sets a password with each SNMP set request that enables access to
the device.
N
N O T E
The default for Read/Write Community is public.
Trap Destination Address Displays the projector’s trap destination address in values between
0.0.0.0 and 255.255.255.255. The trap destination address is the IP
address of the computer assigned to handle unsolicited data
generated by projector trap events, such as power down, power up or
other issues.
A P P E N D I X A
Remotely managing your interactive whiteboard system
56