Smart Technologies SMARTBoard 480iv - Manual (Page 80)

These commands control the current system settings. These commands are available even when the
projector is in Standby mode.
Command Command target range Response
set restoredefaults [none] restoredefaults=done
set lamphrs [target] =0 lamphrs=0
set network [target] =on
=off
network=[target]
N
N O T E
The Network settings features are off by default. Select On to activate these features.
Simple Network Management Protocol (SNMP)
SMART V25 projectors support a list of SNMP commands as described in the management
information base (MIB) file. You can download this file by browsing to smarttech.com/software and
clicking the MIB files link in the Hardware section for the SMART V25 projector.
The SNMP agent supports SNMP version 1. Upload the MIB file to your SNMP management system
application, and then use it as described in your application’s user guide.
A P P E N D I X A
Remotely managing your interactive whiteboard system
70