Honeywell CT3650 - Manual (Page 15)

15 69-1285—2
Program the First Day
Start by programming the wake time and temperature for one day.
❑ Press and release .
❑ Press until the desired day displays. (Mon, Tue, Wed, Thu, Fri, Sat, Sun)
❑ Press time or until the desired time shows in the display.
NOTE: Program times are in 15 minute intervals. For example, 8:00, 8:15, 8:30.
❑ Press or until the desired wake temperature displays.
The setpoint temperature range is 40°F to 90°F (4.5°C to 32°C) for heating and 45°F to 99°F (7°C to 37°C) for cooling.
❑ Press to switch between setpoints.
NOTE: Program times are the same for heating and cooling.
❑ Press or until the display shows the desired temperature setpoint.
NOTE: You can program the fan to On or Auto for each program period. Setting Fan to On runs the system fan
continuously in the program periods.
❑ Press until the fan is at the desired setting (On or Auto).
❑ Press , or and repeat these steps for each program period. The first day is now programmed.
❑ Repeat each step in Program the First Day for the rest of the week.
NOTE: After the first day is programmed, you can copy that day to any other day using procedure in Copy a Day.
❑ Press when the entire week is programmed.
Wake
Day
Heat/Cool
Settings
Fan
Leave Return Sleep
Run
Program