Hunter Fan Hunter Ceiling Fans 41462-01 - Manual (Page 12)

12
41462-01 10/14/2005
®
CONNECTING FAN TO ELECTRI- CONNECTING FAN TO ELECTRI- CONNECTING FAN TO ELECTRI- CONNECTING FAN TO ELECTRI- CONNECTING FAN TO ELECTRI-
CAL SOURCE
CAL SOURCE CAL SOURCE CAL SOURCE CAL SOURCE
1. Connect the wires as shown in
Figure 5. To connect the wires,
twist the bare metal leads to-
gether. Place a wire nut over the
intertwined length of wire and
twist clockwise until tight as
shown.
2. Separate the connected wires by
placing the green and white wires
on one side of the outlet box and
the black wires on the other side
of the outlet box.
CAUTION CAUTION CAUTION CAUTION CAUTION
Be sure no bare wire or wire
strands are visible after mak-
ing connections.
STEP 5 - WIRING THE FAN STEP 5 - WIRING THE FAN STEP 5 - WIRING THE FAN STEP 5 - WIRING THE FAN STEP 5 - WIRING THE FAN
W W W W WARNING ARNING ARNING ARNING ARNING
• To avoid possible electrical
shock, before wiring fan,
disconnect power by turn-
ing off the circuit breakers
both to the outlet box and
to its associated wall switch
location. If you cannot lock
the circuit breakers in the
off position, securely fasten
a prominent warning de-
vice, such as a tag, to the
service panel.
• All wiring must be in accor-
dance with national and lo-
cal electrical codes and
ANSI/NFPA 70. If you are
unfamiliar with wiring, you
should use a qualified elec-
trician.
W W W W WARNING ARNING ARNING ARNING ARNING
To reduce the risk of fire, elec-
trical shock, or motor damage,
do not lift or carry the fan by
the lead wires.
3. Turn the connectors upward. Push
the wires gently into the outlet
box.