Hunter Fan Hunter Ceiling Fans 41462-01 - Manual (Page 16)

16
41462-01 10/14/2005
®
STEP 8 - ATT STEP 8 - ATT STEP 8 - ATT STEP 8 - ATT STEP 8 - ATTACHING THE SWITCH HOUSING ACHING THE SWITCH HOUSING ACHING THE SWITCH HOUSING ACHING THE SWITCH HOUSING ACHING THE SWITCH HOUSING
Figur Figur Figur Figur Figure 8a - Attaching Upper Switch e 8a - Attaching Upper Switch e 8a - Attaching Upper Switch e 8a - Attaching Upper Switch e 8a - Attaching Upper Switch
Housing to Switch Housing Mount- Housing to Switch Housing Mount- Housing to Switch Housing Mount- Housing to Switch Housing Mount- Housing to Switch Housing Mount-
ing Plate
ing Plate ing Plate ing Plate ing Plate
Housing
Assembly
Screw Switch
Housing
Mounting
Plate
Wires for
Optional
Light Kit
Upper
Switch
Housing
Figur Figur Figur Figur Figure 8b - Mounting the Upper e 8b - Mounting the Upper e 8b - Mounting the Upper e 8b - Mounting the Upper e 8b - Mounting the Upper
Switch Housing Switch Housing Switch Housing Switch Housing Switch Housing
CAUTION CAUTION CAUTION CAUTION CAUTION
Make sure the upper switch
housing is securely attached to
the switch housing mounting
plate. Failure to properly at-
tach and tighten all three hous-
ing assembly screws could re-
sult in the switch housing and
light fixture falling.
The switch housing is made up of
two sections: the upper switch hous-
ing, and the lower switch housing.
A A A A ATT TT TT TT TTACHING THE UPPER SWITCH ACHING THE UPPER SWITCH ACHING THE UPPER SWITCH ACHING THE UPPER SWITCH ACHING THE UPPER SWITCH
HOUSING HOUSING HOUSING HOUSING HOUSING
1. Partially install two #6-32 x 3/8"
housing assembly screws into the
switch housing mounting plate as
shown in Figure 8a.
2. Feed the two optional accessory
light kit wires with the attached
wire nuts through the center
opening of the upper switch
housing. See Figure 8a.
3. Align the keyhole slots in the up-
per switch housing with the hous-
ing assembly screws installed in
sub-step 1.
4. Turn the upper switch housing
counterclockwise until the hous-
ing assembly screws are firmly
situated in the narrow end of the
keyhole slots as shown in Figure
8b. Install the one remaining #6-
32 x 3/8" housing assembly screw
into the third hole in the upper
switch housing. Tighten all three
screws firmly.