Hague Quality Water Intl WATERMAX 60 SERIES - Manual (Page 7)

WaterMax 60 Series Owner’s Manual 11/10/2008 7
Customer Settings
Service Settings must be set before Customer Settings; Service Settings should be set during installation of the
appliance.
To set Customer Settings, press and hold the Customer Settings button for about three seconds while
“Customer Setting” displays. Release the button when “Set Time” displays.
Note: If a value displayed on the LCD is correct, press Next to move on to the next programmable value.
Step 1 Set Time of Day
Display reads “Set Time” followed by the current time that is set; the cursor will be under the
second hours digit.
To Change the Time of Day
A.
Press Change Digit repeatedly until the current hour is displayed.
B.
Press Select Digit to set the hour and move the cursor to the right.
C.
Do the same to set the minutes. Select AM or PM. When the desired time is displayed,
press Next.
Step 2 Set Regeneration Time
Display reads “Regeneration Time” followed by the current regeneration time that is set; the
cursor will be under the second hours digit.
To Change the Regeneration Time
A.
Follow the procedure outlined above for setting the time.
B.
When the desired regeneration time is displayed, press Next.
Step 3 Set Number of People
Display reads “Number of People” followed by the current setting for the number of people in the
household; the cursor will be under the tens digit.
To Change the Number of People
A.
Press Change Digit repeatedly until the desired value is displayed; values will cycle from
0 to 9.
B.
Press Select Digit and the cursor moves to the right.
C.
When the desired number of people is displayed, press Next.
Step 4 Set Day of Week
Display reads “Set Day of Week” followed by the current setting for the day.
To Change the Day
A.
Press Change Digit repeatedly until the desired day is displayed. Press Next.
B.
The value is saved and the controller returns to Normal operating mode.
Note: Whenever you experience an electrical outage, check your controller for the correct time and date. Make
any necessary corrections.