Hollywood VR-652 - Manual (Page 14)

ENGLISH
14
• Use the remote control unit within a range of about 5
meters (16 feet) and angles of up to 30 degrees aiming
at the remote sensor.
REMOTE CONTROL OPERATION RANGE OPERATING COMPONENTS WITH REMOTE
CONTROL
Example) When selecting "MAIN" to operate this unit.
1.
Enter the setup code for each component other
than this unit you wish to control. (For details,
refer to "ENTERING A SETUP CODE" on page
13.)
2.
Turn on the component you want to operate.
3.
Press the DEVICE button on the remote control
corresponding to the component you wish to
operate.
4.
Aim the remote control at the REMOTE
SENSOR of the component you wish to control
and press the button corresponding to the
operation you want.
LOADING BATTERIES
• Remove the batteries when they are not used for a
long time.
• Do not use the rechargeable batteries(Ni-Cd type).
• Be sure to use alkaline batteries.
• When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries within
several minutes after removing old batteries.
• If the batteries are removed or have been exhausted for a longer period of time, memorized contents will be cleared.
Should this happen, you should memorize them again.
1.
Remove the cover.
2.
Load two batteries ("AAA" size) matching the polarity.
Note :
• Remote operation may become unreliable if the remote
sensor is exposed to strong light such as direct sunlight
or inverted fluorescent.