Troubleshooting guide – Hollywood VR-652 User Manual

Page 53

Advertising
background image

ENGLISH

53

Troubleshooting Guide

If a fault occurs, run through the table below before taking your system for repair.
If the fault persists, attempt to solve it by switching the unit off and on again. If this fails to resolve the situation,
consult your dealer. Under no circumstances should you attempt to repair the unit yourself. This could void the
warranty.

REMOTE CONTROL UNIT

PROBLEM

POSSIBLE CAUSE

REMEDY

No operation

• Batteries are not loaded or exhausted.
• The remote sensor is obstructed.

• Replace the batteries.
• Remove the obstacle.

PROBLEM

POSSIBLE CAUSE

REMEDY

No power

No sound

Noise or distorted sound

• The AC input cord is disconnected.
• Poor connection at AC wall outlet or the outlet is

inactive.

• The speaker cords are disconnected.
• The volume is adjusted too low.
• The MUTING button on the remote control is

pressed to ON.

• Incorrect selection of the input source.
• Incorrect connections between the components.

• Poor connections.

• Connect the cord securely.
• Check the outlet using a lamp or another

appliance.

• Check the speaker connections.
• Adjust the volume.
• Press the MUTING button to cancel the muting

effect.

• Select the desired input source correctly.
• Make connections correctly.

• Check the connections and connect all cords

securely.

MAIN UNIT

[AMPLIFIER SECTION]

PROBLEM

POSSIBLE CAUSE

REMEDY

No playback

Malfunction

No picture

Noisy or distorted picture

Abnormal or no picture

Slight pause of picture

Noise or distorted sound

• The disc is loaded upside down.
• The disc is not playable.
• The disc is dirty.
• The rating level is not set correctly.

• The symbol about invalid operation is displayed.

• The disc is scratched or dirty badly.

• The video cords are disconnected.
• The incorrect selection of input source on the TV.
• The disc is not playable.

• The unit is connected to a VCR directly and the

copyguard function is activated.

• The disc is dirty.
• It is in rapid advance or reverse playback, or in

frame advance playback.

• The resolution of component video output signal

is not selected correctly.

• The layer transition occurs during playback of

DVD Videos recorded in dual-layer format.

• The disc is dirty.

• Reload the disc with the printed side up.
• Use a playable disc.
• Clean the disc.
• Set the rating level setting correctly.(Refer to

"When selecting the PARENTAL CONTROL" on
page 42.)

• Adjust the setting correctly.(Refer to "SYMBOL

ABOUT INVALID OPERATION" on page 17.)

• Wipe off the dirt or load another disc.

• Connect the cords correctly.
• Select the input source correctly.
• Use a playable disc.

• Connect the unit so that the picture signal is

transferred directly to the TV.

• Clean the disc.
• Sometimes a small amount of picture distortion

may appear. This is not malfunction.

• Select the resolution of component video output

signal correctly.

(Refer to "When selecting the SCAN TYPE" on
page 39.)

• Sometimes slight pause may occur.

This is not malfunction.

• Clean the disc

[DVD PLAYER SECTION]

Advertising