Fisher & Paykel CG755 - Manual (Page 13)

11
Installation instructions
Fastening the cooktop to the bench
1 Turn the cooktop upside down and place it on a soft surface.
2 Spread the seal around the edges, with the adhesive side facing down.
3 Mount the supplied front and rear clamps (F and R) and screws (S) onto the cooktop, as shown
(without tightening the screws).
4 Place the cooktop into the cutout, then tighten the screws to clamp the cooktop securely to the
bench.
5 Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge of the
cooktop. Take care not to damage the benchtop.
Note: if your bench is thicker than 40 mm, recess the underside to between 30 and 40 mm.
Fig. 3 Preparing the cooktop before installation
Fig. 4 Fastening the cooktop to the bench
mi
n
S
A
R
mi
n
A
F S
REAR CLAMPS FRONT CLAMPS
40 mm 40 mm 30 mm
30 mm
30 mm 30 mm
R
F
F
R
S
Seal
REAR
FRONT
S
S
S
Adhesive side