Furuno ETR-30N - Manual (Page 25)

7
FURUNO
NETWORK SOUNDER ETR-30N
HOST NAME TX/STBY POWER
ON
OFF
I
O
0
1
2
3
4 5
6
8
7
9
DEFAULT
LED lamp
The lamp flashes when the NavNet display unit
is powered and communicating with the network
sounder.
POWER switch
Turns power
On and off.
HOST NAME Control
Sets host name.
ETR-30N
7. Turn on the ETR-30N and the NavNet display unit.
8. Confirm that the LED lamp flashes.
2.2.2 Sounder source setting
1. Press the [POWER/BRILL] key on the NavNet series unit while pressing and holding
down the [MENU] key. Release the [POWER/BRILL] key when you hear a beep.
2. Release the [MENU] key when the message “STARTING INSTALLATION MODE”
appears.
3. After the radar screen appears, press the [MENU] key.
4. Press the SYSTEM CONFIGURATION soft key.
5. Press the INSTALLATION SETUP soft key.
SYSTEM
CONFIG
GENERAL SETUP
NAV OPTION
SYSTEM SETUP
INSTALLATION SETUP
RETURN
RADAR
MENU
RADAR DISPLAY SETUP
RADAR RANGE SETUP
ARP SETUP
FUNCTION KEY SETUP
SYSTEM CONFIGURATION
Radar menu System configuration menu
INSTALL
SETUP
RETURN
Install setup menu
NETWORK SETUP
RADAR SETUP
NETWORK SOUNDER SETUP
NETWORK SETUP FOR AUX#
# =Shown on Model 1833C only
How to access the installation setup menu (example: radar NavNet unit)