Furuno ETR-30N - Manual (Page 27)

9
2.2.3 Transducer setup
Enter transducer setting correctly.
A wrong transducer setting can damage the
transducer.
CAUTION
Transducer connected to the ETR-30N is programmed in the ETR-30N
1. At the installation menu, press the NETWORK SOUNDER SETUP soft key.
SNDR
SETUP
EDIT
RETURN
IP ADDRESS 172.031.092.001
HOST NAME SOUNDER____
Note: Do not change IP address or host
name from this display.
FREQ
SETUP
Sounder setup
2. Press the FREQ SETUP soft key. (If the FREQ SETUP soft key is not shown, check that
the ETR-30N is powered.) Confirm that sounder source (shown on the network setup
menu, see page 8) and the HOST NAME control setting are the same.
HOST NAME
Control Setting
Host Name
0 (Default Setting) SOUNDER
1 SOUNDER1
2 SOUNDER2
3 SOUNDER3
4 SOUNDER4
5 SOUNDER5
6 SOUNDER6
7 SOUNDER7
8 SOUNDER8
9 SOUNDER9