FMI F48H(I)(R) - Manual (Page 14)

www.fmiproducts.com 122272-01D 14
INSTALLING SCREEN
1. Mount screen rod brackets on left and
right side of firebox with #8 x 1/2" screws
provided (see Figure 21, page 15).
2. Slide round end of screen rod into rings
at top of screen. Attach one push-on nut
to end of rod before attaching last ring of
screen.
3. Insert round end of rod into rod bracket
on left side of fireplace.
4. Mount flat end of screen rod with #10 x
5/8" to center of smoke shelf (see Figure
21, page 15).
5. Install other screen rod in same manner.
installation
Continued
Figure 20 - Grouting Brick
GROUTING INSTRUCTIONS
Material provided:
1 or 2 - 10 lb. bags of cement (depending
on model)
1 or 2 - 10 lb. bags of sand (depending
on model)
Material required:
1 - Piping bag
1 - Joints striker
1 - Heavy duty mixing bucket
1 - Trowel
1. Moisten brick surface with damp sponge
or spray bottle just prior to application.
When bricks are wet, any excess grout
mixture on bricks will easily wipe off.
2. In a heavy duty mixing bucket, pour 4 ½
cups of water. Add 5 lbs. (half of a bag) of
sand and 5 lbs (half of a bag) of cement.
Mix together well using a power drill with
mixing wand attachment to a yogurt like
consistency. Not adding enough was can
lead to grout falling out after burning.
3. The overall length of piping bag should be
about 16". If the bag is longer than 16",
cut it down to size by removing end with
larger opening. This will make the bag
easier to handle.
4. Put 2 to 3 cups of grout mixture into piping
bag making sure the smaller opening is
downward and over a moist towel to avoid
spilling. Place a wet towel over the bucket
making sure it is directly on the surface of
grout mixture. This will keep the mixture
moist and it will not dry out before use.
5. Begin grouting by first doing a “Filler
Pass”. This is done by filling the joint about
3/4 full with grout mixture. It is important
to work with only 6 bricks at a time so
grout doesn't have time to set up before
striking.
6. Complete a “Finishing Pass” around 6
bricks you just put filler pass around. This
is done by slowly filling in remainder of the
joint with a thick amount of grout mixture.
Mixture should be a little higher than the
brick surface.
7. Using a trowel, remove excess grout mix-
ture by moving trowel in the direction of
the joint. Grout mixture in the joint should
now be flush with brick surface. If not
enough grout is applied into each space,
grout may fall out after burning.
8. Using a joint striker, force grout mixture
into joint and sweep back and forth
until grout is smooth and round. If grout
becomes too shallow, add more grout
mixture with piping bag and strike again.
9. Continue procedure around each group of
6 bricks until an entire panel is finished.
10. Using trowel, scrape in direction of joints
to remove any grout that may have col-
lected around bricks during striking. If
desired, take a moist sponge and lightly
sweep over bricks to remove any grout
that may have gotten on bricks. DO NO
PRESS HARD OR RUB IN A CIRCULAR
MOTION. This will press the grout into
brick and turn brick a different color.
Allow 72 hours before operating
fireplace.