Friedrich CP24F30 - Manual (Page 12)

A.
³⁄₄
" (19.1 mm) extending into room
B. Trim
B
A
A. Level
A
■ Use 2" x 4" or thicker lumber for wood frame.
4. Apply wood preservative to the outside exposed surface.
5. Insert the frame in the wall opening. Square and level frame.
6. Attach frame securely to the wall.
Install Cabinet into Wood Frame
1. Remove top channel and both side channels using a ¹⁄₄" nut
driver or socket wrench. Discard top channel and both side
channels.
A. Outside width
B. Outside height
C. Depth
A
B
C
3. Insert cabinet into the framed wall opening. the top of the cbine
should extend ¾" (19.1 mm) into the room. If there is trim, the
cabinet should extend ¾" (19.1 mm) past the trim.
5. Check that air conditioner cabinet is tilted to the outside so that
water will run to the outside.
6. Reuse the insulation to seal opening between cabinet and
frame.
7. Use existing holes in sides and top of cabinet and 7 - #10 x 1"
wood screws (not provided) to attach cabinet to frame.
NOTE: Do not overtighten screws or cabinet will distort and
provide a poor air seal between cabinet and air conditioner.
8. Caulk all outside wall openings around cabinet.
4. Use a level to check that cabinet is level side to side.
Complete Installation
NOTE: Handle air conditioner carefully and gently.
1. Make sure the free end of the ground wire is outside of the
cabinet.
2. Insert air conditioner into cabinet.
A
A
A. Make sure the free end of the ground wire is outside of the cabinet.
¾" Minim
Cabinet fro
1" Thick lumbe
1" Minim
Inside wall
Exterior wa
mum
nt
er
mum
wall
¼" Slope down.
Position and secure cabinet
downward. Slope outside for
drainage.
Max. Wall thickness allowed 8 ½"
s Front edge of louvers must always
be outside of exterior wall surface
2. Cut two pieces of standard 1" lumber (supplied by installer) to the i f t d d 1" l b ( li d b i t
length and width required. Place in front and back of bottom sill
channel. Secure with nails (supplied by installer).
to move and install
10